How to disassemble - Home Use Stainless Steel Juicer

Home > Products > Home Use

Make sure to unplug the power cord from the electrical outlet before starting disassembly. Place the clean, soft towel underneath the screen housing for preventing the damage of parts when dropped. Before start the following steps, let the machine run for about one minute to get rid of excess feed/juice. Remove the Screen Housing Cover.Then, follow the instruction below.

Unplug the power cord from the power cord connector on the rear side of the motor base

unit.

Lift the Clamp up to release.

Hold the motor base unit by one hand and pull the Screen Housing out by the other hand.

*When the screen housing is not released smoothly.

1) Plug the power cord into the electrical outlet.

2) Turn the main (red rocker) switch ON.

3) Press START button and then, slowly pull the screen housing out with careful attention.

The twin gears will be stopped automatically.

4) Turn the main(red rocker) switch OFF.

5) Unplug the power cord from the electrical outlet.

Carefully pull the Twin Gears out by holding with both hands.

Remove fibers lodging on the screen area by using the Screen Cleaning Knife.

Clean the Screen Housing & Twin Gears with the Cleaning Brush under the running water.

*Tips for cleaning the Screen Housing ?Slowly insert the Cleaning Brush into the Screen Housing and then pull the Cleaning Brush out by turning clockwise continuously.
Repeat this step 4 or 5 times.

For keeping the best polish, clean the parts with the soft sponge first and dry it with the soft

towel.

angelia 8500s | angelia 7500 | angelia 5500 | angelia gold | angelia